45
2.9 Installation of Interface Board for Radar
When the interface board for connection of radar(s) is not installed at the factory, install it (in the
DCU) as shown below.
1. Remove ten screws shown below to detach the PCB.
2. Remove the screws shown below to remove the fixing plate.
PCB card case
Fixing plate
Remove this screw
to remove the fixing plate.
3. Connect the flat cable between the two interface boards if it is not already connected.
4. Set the boards in the PCB card case as shown below.
Set larger
board in slot.
Fix boards
with screws.
5. Fix the boards with the screws provided.
6. Reattach the fixing plate and PCB card case.
7. Connect cabling as shown on page 21-24.
To Next Page
Loading...
