39
2.6.2 VR-3012W
Bulkhead mount
1. Unfasten the cover.
2. Lead in wiring through the cable gland and connect it to the terminal board on the rear side
the cover, referring to the interconnection diagram. See page 19 for how to fabricate the cable.
Be sure to ground shield. Tape fabricated part of wiring with vinyl tape.
3. Close the cover.
Flush mount
1. Connect wiring to the terminal board on the rear side of the cover, referring to the
interconnection diagram. See page 19 for how to fabricate the cable. Be sure to ground shield.
Tape fabricated part of wiring with vinyl tape.
2. Fasten the cover to the housing.
After installing microphones, test them
to make sure they are not picking up
noise and that the sound quality is good.
NOTICE
To Next Page
Loading...
