FUTABA 2HR - Reference

30
Reference
If your system fails to operate or you experience a short range problem or erratic control,
check the table below for possible causes. If after you have followed the suggestions
listed the problem is not corrected, return the system to our service department for
inspection and repair.
(ItemCheck)
Troubleshooting
Transmitter
Battery
Dead battery Change the batteries.
Batteries inserted incorrectly.
Reload the batteries in accordance with the
polarity markings
Faulty contact
Check to see if the contacts are bent and not making good
contact
Dirty contacts
Clean the contacts and check for corrosion.
Receiver
Battery
Dead battery Replace or recharge
Wrong polarity
Check connections
Antenna
Near other wiring Move away from wiring
Was antenna cut
Request repair
Is the antenna installed correctly
Refer to the receiver installation.
MonitorLED
Check the LED of the receiver.
Refer to the "How to link the transmitter and the receiver".
Connectorconnections
Wiring incorrect Insert all connectors firmly
Loose connections
Push the connector in firmly
Linkage
Binding or loose Adjust the linkage in model
Is movement stiff
Adjust linkage in model
Motor(Electricpowered)
Noise problems Install capacitors on motor