FUTABA 3PJ Super - A.B.S. Function

51
Select Mode Functions



 
A.B.S. Function
When the brakes are applied while cornering with a 4 Wheel
Drive or other type of vehicle, understeer may occur. The
generation of understeer can be eliminated and corners can
be smoothly cleared by using this function.
Operation
- When the brakes are applied, the throttle servo will pulse
intermittently. This will have the same effect as pumping
the brakes in a full size car.
- The brake return amount, pumping cycle, and brake duty
can be adjusted.
- The region over which the ABS is effective can be set ac-
cording to the steering operation. (Mixing function)
Without A.B.S.
With A.B.S.
1. (A.B.S. function ON/OFF set-
ting)
Call the A.B.S. function set-
up screen by pressing the UP
key three times at the initial
screen.
- 3 times
2. Turn on the A.B.S. function
with the + or - key.
3. (Brake return amount setting)
AB.P
Press the SELECT key once.
The brake return amount set-
up screen is called.
4. Adjust the brake return
amount with the + or - key.
Setting range: 0~100%
- Return to the initial value (50%)
by pressing the + and - keys si-
multaneously for about one sec-
ond.
Blink
Blink
Blink
DIRECT ST.EXP M.SEL
UP
+
SETUP RESET
SELECT DOWN
-
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP
+
SETUP RESET
SELECT DOWN
-
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP
+
SETUP RESET
SELECT DOWN
-
TH.EXP ATV CUSTOM
DIRECT ST.EXP M.SEL
UP
+
SETUP RESET
SELECT DOWN
-
TH.EXP ATV CUSTOM