Levels LV2, LV3 Only Lap Listing LAP-LIST
DEFINITION: Displays all stored lap times, up to 100, and also stores total race
time, including run time after last but before reset/stop.
ADJUSTABILITY:
•
Reset single lap: Select lap, cursor blinks next to it. Press together.
•
Reset all laps in memory: Press and together for 1 second.
INTERACTION:
•
Requires switch assignment for lap counter in the FUNC-SW screen (see pp. 34-35).
•
Requires set up of timer as Lap Memory Timer (see p. 30).
•
Lap Navigation Timer does NOT store lap times (see p. 30).
DESIRED END RESULT: Store multiple lap times to analyze performance after the race.
31
GOAL:
Set up a lap memory timer to track lap times
throughout a race, while using LV2 menus.
(If using LV3, select timer from Menu 1). (If
using LV1, first change level selection to
LV2. See p. 12.)
Where Next:
STEPS:
Assign desired lapstart and restart switches.
Open and select menu 1.
Select TIMER.
Set type to lap memory timer.
Set total race time to 5 minutes.
Set pre-alarm time to warn you race end is
nearing at 15 seconds.
Set total timer/first lap timer to trigger
when throttle is pulled.
Test function on screen.
Close function and menu.
INPUTS:
See FUNC-SW pp. 34-35.
to LAP MEMORY.
to ALRM. to 5m.
to 15s.
Screen reads RDY.
Pull trigger. Timer starts counting.
Press selected switch (ex: PS-1) to store
first lap.
Note screen now displays the first lap’s
time for 3 seconds, then displays current
running lap.
Press selected reset switch to stop timer.
System timer: Reset radio’s total timer after recharging to use as a method of tracking
on time between charges: from home screen, press and hold for one second.
View stored laps (LAP-LIST): See p. 31.
Adjust switch assignments (FUNC-SW): See pp. 34-35.
Place timer setup screen on quick menu for 2-keystroke access (DIRC-CALL): See p. 36.
GOAL:
View laps previously run, then reset all laps,
while using LV2. (If using LV3, select LAP-LIST
from menu 1.) (If using LV1, first change
level selection to LV2, p. 12.)
Where Next:
STEPS:
Open and Select Menu 1.
Select LAP-LIST.
Scroll through laps shown on screen.
Reset all laps to prepare for next practice.
Close function and menu.
INPUTS:
or as needed.
and together for 1 second.
Change timer type to lap navigate timer (laps will not be stored) (TIMER): See p. 30.
Adjust timer settings (TIMER): See p. 30.
Change switch assignment to start/stop lap timer (FUNC-SW): See pp. 34-35.
To Next Page
Loading...
