25
Before Using
3
Pull out the wiring as far as possible from between the wheel unit and APA. Stow the
surplus pulled out wiring in the transmitter.
s"ECAREFULNOTTOSTRETCHTHEWIRING
4
Install the assembled wheel unit and APA
to the transmitter using the screw supplied.
The APA mounting screws are in the hook
and APA mounting screws bag.
Verify the position of the transmitter bottom
holes by mounting angle. The screw used
depends on the position of the bottom hole.
Stow the surplus wiring here.
Transmitter bottom hole
*The figure below is an installation example.
Dummy screw
$UMMY SCREWS X SCREW
hide the APA hole where there is
no bottom hole in the transmitter.
5SE X CAP TAPPING SCREW TO INSTALLTHE !0! AT
the 3 bottom holes in the transmitter
Steering wheel mounting screw
5
Install the steering wheel
using the screw.
To Next Page
Loading...
