FUTABA 4PK 2.4GHZ - Page 25

26
Before Using
Modifying for left-hand use
1
Remove the wheel section rear
cover .
s4HEREARCOVERCANBEEASILYREMOVEDBYIN-
serting a coin, etc. into the slot at the bottom
of the rear cover.
s/BTAINAMMHEXWRENCHANDPHILIPSSCREWDRIVER
s)NSTALLTHESTEERINGWHEELUNITREMOVEDASDESCRIBEDONTHEPRECEDINGPAGEASFOLLOWS
2
Push in the disconnected connector
so that it can be connected at the
opposite side.
3
At the opposite side, connect the
steering wheel unit connector and
Install the steering wheel unit,
steering wheel cover, and wheel to
their original positions.
s!T THISTIMEBESURE THATTHEWIRING ISNOT
pinched between the wheel unit and trans-
mitter.
Stow the surplus wiring here.