EasyManua.ls Logo

FUTABA 9 CHP SUPER - Aircraft (ACRO) Menu Functions

FUTABA 9 CHP SUPER
109 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20
AIRCRAFT (ACRO) MENU FUNCTIONS
Please note that all BASIC menu functions are the same for airplanes (ACRO), sailplanes (GLID1FLAP/2FLAP/2FL-C), and
helicopters (HELISWH1/SWH2/SWH4/SR-3/SN-3/SR-3s). The glider BASIC menu does not include IDLE-DOWN or THR-CUT;
the helicopter BASIC menu includes additional features (swashplate adjustment and throttle/pitch curves and revo for
Normal flight mode) that are discussed in the Helicopter section.
Map of ACRO BASIC functions ....................................... 21
Quick Guide to Setting up a 4-channel Airplane ....... 22
ACRO BASIC MENU FUNCTIONS ............................... 25
MODEL Submenu: MODEL SELECT, COPY and NAME.25
PARAMETER Submenu: TYPE, MODUL, ATL, AIL2,
& RESET ..................................................................... 28
Servo REVERSE .......................................................... 31
END POINT ................................................................. 32
Idle Management: IDLE DOWN and THR-CUT ............ 33
Dual/Triple Rates and Exponential (D/R,EXP) ........... 35
TIMER Submenu ......................................................... 38
Auxiliary Channel assignments and
CH9 reverse (AUX-CH) ............................................... 39
TRAINER ..................................................................... 40
TRIM and SUB-TRIM ................................................... 41
SERVO Display ........................................................... 42
Fail Safe and Battery FailSafe (F/S) .......................... 43
ACRO ADVANCE MENU FUNCTIONS .......................... 44
Wing types ................................................................. 44
FLAPERON .............................................................. 45
FLAP TRIM ............................................................. 46
Aileron Differential (AIL-DIFF) .............................. 47
Using a 5-channel receiver: AIL-2 ......................... 48
ELEVON (see tail types) .......................................... 49
Tail types ................................................................... 49
ELEVON .................................................................. 49
Twin Elevator Servos (AILEVATOR) ....................... 50
V-TAIL ..................................................................... 51
SNAP ROLL ................................................................. 52
Mixes: definitions and types ...................................... 54
ELEV-FLAP.............................................................. 55
AIRBRAKE/BUTTERFLY (crow) ............................... 56
Airbrake switch selection (SW SELECT) ................ 56
THROTTLE-NEEDLE................................................. 58
THROTTLE DELAY ................................................... 59
Linear, Prog. mixes 1-5 ......................................... 60
Curve, Prog. mixes 6-7 .......................................... 63
GYA gyro mixing (GYRO SENS) ............................ 65
Other Equipment ....................................................... 66

Table of Contents

Related product manuals