FUTABA FX-36 - Page 98

98
＜ Linkagemenu ＞
rpm
Setstherpmonwhich
thealarmoperates.
↑Anupwardarrow
willshowthatanalarm
willsoundwhenthe
rpmrisesabovetheset
value.
↓Adownwardarrow
willshowthatanalarm
willsoundwhenthe
rpmfallsbelowtheset
value.
Alarmischosenfrom
Buzzer,Voice,and
Inhibit.
AllowsSpeechtobe
turnedONorOFF.
ŏ Tap the [rpm sensor] button in the Telemetry screen
to call the setup screen shown below.
Max.andmin.values
sincethepower
wasturnedONwill
display.
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
FASSTest12CH mode.
*The FASSTest18CH /T-FHSS mode can use all the telemetry
functions.
Type1
Type2
Type3
"Vibrator"type
Ifthefollowingtypesareselected,thetransmitter
willvibrateduringthewarning.
Telemetry:RPMSensor
Displaying data from the rpm
The RPM Sensor screen is used to set up an
optional rpm sensor and display the rotation
information it transmits.
The rotation of the model (engine, motor, etc.)
which is Àying can be shown.
If it becomes higher or lower than the setting, an
alarm and/or vibration will alert you.
Alarm set : Over
(
Under
)
rotations
1. Tap Alarm and choose from Bu]]er, Voice,
and Inhibit.
2. Choose "Inhibit" for Vibrator if no
t
using the
vibrator alarm. If using vibrator, choose one
of the three types.
3. Tap to the Limit [
xxx
rpm] item .
4. Adjust the rate using the "ʈʈ" "ʈ" "ʆ" "ʆʆ"
buttons.
Initial value: Ń 2,000rpm Ņ 0rpm
Adjustment range: 0rpm~150,000rpm
(ŃLimit
≧
ŅLimit)
*When the screen is tapped for one second, the rate is reset
to the initial value.
5. To terminate the input and return to the
original state, push the H/E button.
*Anrpmsensormustbeinstalledintheaircraft.
"Magnet"
"Optics"
"Brushlessmotor"
SBS-01RM→
SBS-01RO →
SBS-01RB→
Gearratio
Blade
Pole
1.00~99.00
2~10
2~30
ŏReturn to
Linkage menu