4. Operating System and Equipment
4.4.2 Front Seats
When measuring the depth of seat cushion,
adjust the seat to the middle
of the sliding rail and
adjust the seat backrest to serviceable condition
(25°).
Warning
• Never place any objects under the front seats.
Otherwise, these objects may be jammed
between the seat and guide rail, hindering
seat locking.
• To adjust the
seat, you need to deviate from
your correct sitting posture. Therefore, front
seats must be adjusted when the vehicle
stationary.
•
After the Ignition switch is switched to "OFF"
position, the electric adjusting mechanism of
seats* still works. Never leave
the vehicle
to prevent her/him from improper
operation of electrical seats and causing
accidents.
Power Seat*
Forward/Backward adjustment of seat:
– Move the switch in the direction of arrow ① or
② to slide the seat forward or backward.
Vertical adjustment (driver's seat)*:
– Move the switch in the direction of arrow ③ or
④ to raise or lower the seat.
Forward/Backward adjustment of backrest:
– Move the switch in the direction of arrow ⑤ or
⑥ to tilt the backrest forward or backward.
Adjustment of Lumbar Support of Driver's Seat*
– Enable the upward support, downward
retraction, forward support and backward
retraction respectively by pressing the switch
in the directions of arrows ①, ②, ③ and ④.
105
To Next Page
Loading...
