8. Handling of Accident
8.6 Emergency Start
Jumper Cable
If you cannot start the engine because of low
battery energy, you can use the jumper cable to
connect with another vehicle’s battery to start the
engine.
Caution
Ensure that the clamp of the jumper cable
does not contact other metal.
Warning
• Engine compartment is a hazard area where
improper operation may cause injuries or
deaths.
• Before battery operation, car
efully read and
comply with relevant safety warnings and
instructions about the operation of the battery.
Connect the positive terminals of the batteries
before connecting the negative ones.
– Switch the Start switch to “OFF” position.
– Connect the end ① of the red cable to the
positive electrode (+) of flat battery “A”, and
the other end ② to the positive electrode (+) of
booster battery “B”.
– Connect end ③ of the black cable to the
negative electrode (-) of booster battery “B”,
and the other end ④ to the engine cylinder
block or the metal component securely
connecting with the engine cylinder block of
the vehicle with flat battery “A”.
Caution
Place the jumper cables in position to prevent
them from touching the moving parts of the engine.
– Start the engine of the vehicle with booster
battery and let it idle, and then start the engine
of the vehicle with flat battery until the engine
runs smoothly.
313
To Next Page
Loading...
