4. Operating System and Equipment
AUTO Mode
When AUTO button is pulled/pushed, the
button light is on, the A/C system enters the AUTO
mode, and the following items are controlled
automatically as per respective set value:
– Air vent temperature
– Air volume at the air outlet
– Air Vent Mode
– Air circulation mode
– Working conditions of A/C.
– Working conditions of anion purifier
By operating or button, the indicator light
of AUTO button goes off, and the A/C system exits
the auto mode.
Air Speed Setting
In the auto mode, the A/C system controls the
air speed automatically. By operating button, the
system switches from the auto mode to the manual
mode.
There are seven air speed scales (1~7). When
button is operated to control the air speed, the
corresponding air speed scale will be shown on the
display:
– By pulling/pushing button, the air speed
increases/decreases by one scale.
In AUTO mode, the air speed is a part of the
automatic control logic. The air speed is not limited
to 7-scale control in manual state, but there are
only 7-scale indicating bars on the display, so the
number of the indicating bars shown is the
proximate one. To achieve the target interior
temperature, the air speed will be adjusted
automatically.
A/C Off
When the air speed of the blow is Scale 1,
press button to turn off the A/C system with an
air speed of 0.
After the A/C system is turned off, button,
button and button* can be operated effectively
without turning on the A/C system. It is ineffective
to operate button. The A/C system can be
turned on by operating AUTO button, A/C button,
button or button.
When the air speed is greater than Scale 1,
long press button to turn off the A/C system.
130
To Next Page
Loading...
