4. Operating System and Equipment
Rear Windshield Defrosting
Pull/push button to light on the button light,
enable the rear windshield defrosting function, and
heat the rear windshield electrically.
During the rear windshield defrosting,
pull/push button again to light off the button light
and disable the rear windshield defrosting function.
If the rear windshield defrosting function is not
manually off, this function will be off automatically
after continuous working for 15 minutes.
If the engine is not started, prolonged rear
windshield defrosting function may cause low
battery voltage, leading to
start failure of the
vehicle.
Air Vent Mode
Pulling/pushing button can switch among
the following air outlet modes in loop:
– Face blowing mode: Air is blown out from
the air outlet of the instrument panel.
– Face and foot blowing mode: Air is blown
out from the air outlets of the instrument panel
and the footwell.
– Foot blowing mode: Air is blown out from
the air outlet of the footwell.
– Foot and front windshield blowing mode: Air
is blown out from the defrosting air outlet of
the front windshield and the air outlet of the
footwell.
139
To Next Page
Loading...
