5. Driving Directions
Limphome Mode
If "No key detected" is shown on the
instrument cluster display due to low power of the
smart key, please try to place the smart key
horizontally on the key mark at the bottom of the
front cup holder, press the start switch to switch it
to "ACC" or "ON" and depress the brake pedal to
change the indicator light of the start switch to
green, and then press the start switch again to start
the engine. This start method is temporary
emergency startup. Please replace the battery of
smart key as soon as possible.
Conventional Ignition Switch*
The Ignition switch has 4 gears in total.
– LOCK: The circuit is disconnected and the key
could be pulled out only at this gear.
– ACC: At this position, the circuits of power
outlet and other accessories are switched on.
– ON: Instrument light is on and all electrical
device circuits are switched on; the ignition
switch will be switched to this position after
the engine is started.
– START: This gear is only used to start engine.
When the key cannot or is hard to be twisted
from the “LOCK” position to "ACC", it can turn
the
steering wheel slightly, and separate the LOCK
mechanism on steering wheel until it can twist the
key to switch the ignition lock.
158
To Next Page
Loading...
