English
7
61
Should the
“PRE-INFUSION” function
be active (see par. "Special
functions"). Wait until the
pre-infusion function is
complete before stopping
delivery in progress.
During the programming of
a unit the function of the
other units is deactivated
as well as tea dispensing.
To programme the other units, press the specific
programming key of each unit and carry out the same
operations as undertaken on unit 1. In this case any
variations in the measures are activated only on the unit
on which one is actually working.
7.2 Tea measure programming (hot
water)
It is possible to modify the timed tea measures according
to the following sequence:
Press key T5 of coffee unit 1 and keep pressed down for
over 5 seconds and check that all the keyboard led
indicators come on.
Press the T6 tea key within 30 seconds (programming
time-out).
This begins the tea water delivery operation.
Once the required measure is obtained press T6 again to
suspend water delivery. In this way the new tea water
delivery time is memory and all the keyboard leds go out.
Press key T5 to immediately escape from the programming
stage.
To Next Page
Loading...
Need help?
General
