3. Setup
3.1 Setting up the Printer
Place the printer on a flat, secure surface, then follow the steps below:
1. Plug the power cord into the AC power cord socket at the rear of the printer. Then,
plug the other side into a properly grounded power outlet.
2. Connect the printer to the computer with the provided USB cable.
3. Push the power switch on “-” side to open the power of printer.
NOTE:
* Please switch OFF printer power prior to plugging in the power cord to printer power jack.
* The interface picture here is for reference only. Please refer to the product specification for the
interfaces availability.
GA-2408T & GA-3406T & GA-6404T Series
To Next Page
Loading...
Need help?
General
