4. Button Functions
4.1 Regular Button Functions
This printer has one button for feed, pause or cancel errors. There are different
functions in different modes, as shown in the following table:
When the printer is ready (Blue LED ON), press
this button once, and the label will advance to the
front of the next label
Wait for
push button
to print
When the button Demand function is activated,
the printer will stop after printing and wait for the
user to press this button before printing the next
label.
When the printer is printing continuously,
pressing the (PAUSE) button will pause printing.
The power indicator is blue flashing. Just press the
button again, and the print job returns to normal.
When the error RED is on, press the (PAUSE)
button once, the printer will cancel the error and
resume printing function, and reprint the label
layout when the error occurs.
4.2 Power-on Utilities
This printer has six power-on functions for setting or testing the printer's hardware.
Press these buttons at the same time when the power is turned on, and release the
buttons with the light signal to activate these functions.
Follow these steps to enable the boot function:
A. Power off the printer
B. Make sure the printer is loaded with paper and close the
printer cover
To Next Page
Loading...
Need help?
General
