5.13 Printer Utility - Command Tool
1. Send Command
The box can input instructions. After clicking the “Send Command”, the
command can be transmitted to the printer, so that the printer can execute the
incoming command. Please refer to following figure 5.14:
2. Send File
This command can transmit the instruction document to the printer, and the
printer can recognize the instruction and execute the instruction in the
document. Please refer to following figure 5.15:
Click “Send File”, the file selection interface will appear, select the corresponding
file. The document encoding format should be saved to ANSI, otherwise some
instructions will not be recognized.
To Next Page
Loading...
Need help?
General
