Gainscha GA-3406T Series User Manual

89
Poor print quality
 Ribbon and media is loaded
incorrectly.
 Dust or adhesive accumulation on
the print head.
 Print density is not set properly.
 Printhead element is damaged.
 Ribbon and media are
incompatible.
 Reload the supply.
 Clean the print head.
 Clean the platen roller.
 Adjust the print density and print
speed.
 Run printer self-test and check
the print head test pattern if there
is dot missing in the pattern.
 Change proper ribbon or proper
label media.
 The print head mechanism does
not latch the print head properly.
Skip labels when
printing
 Label size is not specified
properly.
 Sensor sensitivity is not set
properly.
 The media sensor is covered
with dust.
 Check if label size is setup
correctly.
 Calibrate the sensor by Auto Gap
or Manual Gap options.
 Clear the GAP/Black mark sensor
by blower.
The printing position of
small label is incorrect
 Media sensor sensitivity is not
set properly.
 Label size is incorrect.
 The vertical offset setting in the
driver is incorrect.
 Calibrate the sensor sensitivity
again.
 Set the correct label size and gap
size.
 If using the software BarTender,
please set the vertical offset in the
driver.
Missing printing on the
left or right side of label
 Wrong label size setup.
 Set the correct label size.
Wrinkle problem
 Ribbon installation is incorrect.
 Media installation is incorrect.
 Print density is incorrect.
 Media feeding is incorrect.
 Please set the suitable density to
have good print quality.
 Make sure the label guide touch
the edge of the media guide.
Gray line on the blank
label
 The print head is dirty.
 The platen roller is dirty.
 Clean the print head.
 Clean the platen roller
Irregular printing
 The printer is in Hex Dump mode.
 Turn off and on the printer to skip
the dump mode.

Gainscha GA-3406T Series Specifications

General

Brand	Gainscha
Model	GA-3406T Series
Category	Label Maker
Language	English