GAL GALaxy eHydro - Page 28

GALaxy eHydro Elevator Controller Section 2 –Installation
2-10
Step 4: Install the selector mounting bracket.
• Mount the selector mounting bracket to the cross head.
• Use the roller or slide shoe guide bolts to hold the camera bracket. The face of the bracket
should be about 5 ½ inches from the back of the rail. See Figures 2-10 and 2-11.
• The back of the bracket should be as close as possible to the crosshead channel.
• Use a level and make sure it is plumb and level.
Figure 2-9: Lower Bracket with Springs Properly Compressed to the Marks
Figure 2-10: APS Camera and Mounting Bracket