Galcon Dc-4 Installation And Operating Instructions

4.Additional Functions
4.1 One-Time Irrigation
This function is used to program the
irrigation controller to operate the
irrigation system once only, for the set
irrigation duration, at the set time.
(Duration set as described in Section
3.4).
1.Press © until EX appears.
2.Press © several times (for all the days
of the week) until <S appears, and
fn LE blinks on the display.
M Tu W Th F Sa Su
6056 - DC 6s
3.Go to Section 4.3 to set the start day and time.
4.2 Cyclical Irrigation
This option is used to program the
irrigation controller to operate the
irrigation system in a cyclical manner,
once every x days, for the irrigation
duration.
(Note: Duration for which valve stays
open set as described in Section 3.4).
1. Press © until BS appears.
2. Press ® several times (for all the days
of the week) until & appears, and
Hn LE blinks on the display.
M Tu W Th F SaSu
now
sensor
W.open
w.close
manua
rain off
6056 - DC6s
3. With the display blinking, press ® or ©. The interval between irrigation
sessions (irrigation cycle) in days, hours or minutes is displayed. For
example, if you set 2 days, the irrigation will be performed every two days
for the defined duration.
4. In the "S" series of professional controllers, the irrigation cycle can be
programmed from one minute up. The settings are performed in the
same manner.
14

Galcon Dc-4 Specifications

General

Brand	Galcon
Model	Dc-4
Category	Controller
Language	English