Name: Galcon Dc-4
Brand: Galcon
Rating: 4 (1 reviews)

To Next Page

To Previous Page

2.5

Wiring

the

Solenoids

the

DC-4,

DC-4S

and

DC-6S

Models

the

DC-4,

DC-4S

and

DC-6S

models,

connect

the

valves

the

cables

emerging

from

the

controller

according

the

illustration

and

explanation

below.

*In

specific

models

only.

Labeled

cables

emerge

from

the

controller

[1].

The

end

each

cable

protected

cover

that

must

removed

prior

connecting

the

cable.

The

cables

are

specifically

designed

connect

Galcon

type

irrigation

valves

and

solenoids

[3].

The

controller

and

its

connections

are

waterproof.

safeguard

the

waterproof

characteristics,

compliance

with

the

following

essential:

not

remove

protective

covers

from

cables

that

are

not

connected

valves.

Exposed

cable

ends

can

short-circuit

with

each

other

with

conducting

bodies.

Connect

the

cables

the

valves

(3)

using

the

special

waterproof

connectors

(2)

supplied

with

the

product.

See

illustration.

Cut

away

the

covering

from

the

controller

cable

(1)

near

the

end

the

cable

and

expose

the

cable

leads

from

the

black

insulation.

The

solenoid

cables

have

three

wires:

white,

red

and

black.

not

expose

the

three

wires

from

their

colored

insulation.

Galcon Dc-4 Installation And Operating Instructions

Table of Contents

Other manuals for Galcon Dc-4

Questions and Answers:

Galcon Dc-4 Specifications

Related product manuals

Brand	Galcon
Model	Dc-4
Category	Controller
Language	English