Configuration
191 · Computer and console modules (DP-HR)
Enable/disable the startup without a keyboard
By default, console modules start without a keyboard. As an alternative, the console
module can interrupt startup by showing a message regarding the missing keyboard.
Once you connect a keyboard to the console module, the startup process continues.
How to enable/disable the startup of a console module without a keyboard:
1. Press the Alt+Num (default) hotkey to open the OSD.
2. Select Keyboard/Mouse and press Enter.
3. Select the Keyboard required entry and press F8 to select one of the following
options:
4. Press F2 to save your settings.
Activating or resetting a PS/2 mouse
Compared to USB mouses, PS/2 mouses do not support hot plug technology. You
can therefore insert the PS/2 plug during operation, but it may be possible that the
computer does not detect the input device.
In order to activate or reset the PS/2 mouse, the matrix system can be used to send
a special command to the computer connected to the computer module.
How to start and use the Mouse utility function:
1. Press the Alt+Num (default) hotkey to open the OSD.
2. Select Mouse utility and press Enter.
3. Select one of the following functions and press Enter:
no:
Console module can be started without a keyboard (default).
yes:
Console module can be started only when a keyboard is connected.
NOTE:
Since the commands differ depending on the used mouse type and the
installed operating system, four different functions are provided.
Reset Mouse:
Resets the PS/2 mouse interface of a Windows
computer
Enable mouse (for Unix):
Activates the PS/2 mouse of a Linux computer
Enable Intelli:
Activates the PS/2 wheel mouse of a Linux computer
Enable Intelli-Explorer:
Activates the PS/2 wheel mouse with additional
keys of a Linux computer
To Next Page
Loading...
