Configuration
Computer and console modules (DP-HR) · 192
Resetting the default settings
This setting resets the default settings of the extender mode. All settings that have
been changed by the user are reset.
How to reset the default settings of the extender mode:
1. Press the Alt+Num (default) hotkey to open the OSD.
2. Select Console utility and press Enter.
3. Select Set system defaults and press Enter.
Showing status information
The OSD shows you information about the console module and the connected
computer
module.
Several menus provide you with the following information:
FIRMWARE INFO
This menu shows information about the console module (console) and the computer module (target).
ID: Device ID
Version: Installed firmware version
Device: Type name
Firmware: Name of installed firmware
HOTKEY
Local Hotkey (Modifier+Key)
Modifier: Modifier key of key combination
Key: Hotkey of key combination
Local OSD via 2x keypress
Modifier: Configured key to open the OSD via double keypress
Local selectkeys
Keys: Selected set of select keys:
HARDWARE INFORMATION
Serial number: Serial number of console module
To Next Page
Loading...
