GANSER LIFTSYSTEME GTLE - Service Access; Platform Stairlift Operating Options; Operation by Means of External Control; Figure 6: Service Cover on the Rear of the Lift Unit

Page 10 of 35 Version 1.2 GTLE Operating Manual
6.3. Service access
The GTLE is exclusively battery-powered. The main switch is located directly on the load-
carrying device under a cover on the back of the lift unit. The power supply can be interrupted
by turning the main switch to -0-. In this position, the main switch can be shut off.
7. Platform stairlift operating options
Stairlifts are required to operate on the “dead man’s control” principle. This means that the
stairlift only moves as long as the keys on the control unit or remote control are pressed. This
gives the user a feeling of safety and avoids anxiety.
7.1. Operation by means of external control
External controls (cf. Figure 2) are permanently mounted at the respective stopping points and
are equipped with a key switch as standard. The lift system can only be operated with suitable
keys.
The following controls are located on external controls:
1
Run command transmitter UP button
Depending on the direction of the arrow, the
stairlift will go up or down.
2
Run command transmitter DOWN
button
3
Open platform
Depending on the direction of the arrow, the
platform is folded down or up.
4
Close platform
7
Key switch The system can only be put into operation with
the key
Table 3: External control operating options
Figure
6
: Service cover on the rear of the lift
unit