GANSER LIFTSYSTEME GTLE - Operation on the Platform Stairlift; Operation with Cable Remote Control; Using the Stairlift; Calling and Sending the Carriage

Page 12 of 35 Version 1.2 GTLE Operating Manual
If the password has been entered incorrectly, please press the fourth key of the password
combination, i.e. the “Arrow down” key (Figure 3, Pos. 2). All LED lights switch off and it is
possible to start the password entry again.
7.3. Operation on the platform stairlift
Every GTLE platform stairlift is equipped with a user interface as standard (cf. Figure 1).
Controls located directly on the stairlift are given priority over wireless controls. The following
elements are located on the user interface:
1
Right arrow travel command
transmitter
Depending on the direction of the arrow, the stairlift
moves in the respective direction
2
Left arrow travel command
transmitter
5
Emergency signal
Activates an acoustic signal or a self-dialling
emergency call device (optionally available)
6
Emergency stop button
After actuation, the stairlift stops. To unlock, the
button must be turned.
Table 5:Operating options on the lift
7.3.1. Operation with cable remote control
Optionally, the platform stairlift can be equipped with a cable remote control, which promises
ergonomic operation when using a folding seat. The following operating options are located on
the cable remote control:
1
Run command transmitter UP
button
Depending on the direction of the arrow, the stairlift
will go up or down.
2
Run command transmitter
DOWN button
Table 6: Cable remote control operating options
8. Using the stairlift
8.1. Calling and sending the carriage
From any stopping point, the stairlift can be brought in or sent to another stopping point. When
using an external control, turn the key switch on the corresponding external control to the -ON-
position.
Calling / sending the carriage from the upper to the lower stopping point:
Press the (DOWN) key (cf. Figure 2, Pos. 1) continuously.
After a delay time of max. 2 seconds, the carriage starts moving in the direction of
the lower stopping point.
Calling / sending the trolley from the lower to the upper stopping point:
Press the (UP) key (cf. Figure 2, Pos. 2) continuously.
After a delay time of max. 2 seconds, the carriage starts moving in the direction of
the upper stopping point.