18
IMPORTANT SAFETY INSTRUCTION
WIRING DIAGRAM CONNECTION
1 LOW TENSION CONNECTOR
1.1 CONNECTION OF PUSHBUTTONS/SELECTORS
1.2 CONNECTION TO THE SAFETY DEVICES
1.2.1 SAFETY BEAMS
1.2.2 SAFETY BEAMS WITH FUNCTIONING TEST
1.2.3 SAFETY EDGE
1.3 ACCESSORIES’ CONNECTION
2 230V~ CONNECTION BOARD
2.1 CONNECTION OF THE MOTOR AND OF THE POWER SUPPLY
2.2 PROTECTION FUSES
3 CONTROL UNIT PROGRAMMING
3.1 BASIC PROGRAMMING
3.1.1 RESET PROCEDURE
3.2 RADIO TRANSMITTERS’ PROGRAMMING
3.3 TRANSMITTERS’ PROGRAMMING THROUGH SEQUENTIAL CONTROL START/STOP (SS)
3.4 PROGRAMMING OF A 3-BUTTONS TRANSMITTERS
3.4.1 PROGRAMMING OF THE OPEN BUTTON
3.4.2 PROGRAMMING OF THE CLOSE BUTTON
3.4.3 PROGRAMMING OF THE STOP BUTTON
3.5 PROGRAMMING OF THE COURTESY LIGHT CODE
3.6 REMOVE TRANSMITTERS FROM THE MEMORY
3.7 PROGRAMMING WORKING TIMES
3.7.1 PROGRAMMING OF THE WORKING TIME
3.7.2 PROGRAMMING OF THE PAUSE TIME
3.7.3 EXCLUDING THE AUTOMATIC CLOSURE
4 SELECTION OF THE WORKING LOGIC
4.1 DEAD MAN CLOSURE
4.2 SAFETY BEAM LOGIC
4.3 ACTIVATION OF THE SAFETY BEAMS’ TEST
4.4 SELECTION OF THE SAFETY EDGÉS TYPE
4.5 COURTESY LIGHT LOGIC
5 LED SIGNALS
6 PROBLEM SOLVING
GENERAL SALE CONDITIONS
EN
Control unit with integrated receiver
pg. 2
pg. 20
pg. 21
pg. 21
pg. 21
pg. 21
pg. 22
pg. 22
pg. 23
pg. 23
pg. 23
pg. 24
pg. 24
pg. 24
pg. 24
pg. 24
pg. 25
pg. 25
pg. 25
pg. 25
pg. 26
pg. 26
pg. 26
pg. 26
pg. 27
pg. 27
pg. 28
pg. 28
pg. 28
pg. 28
pg. 29
pg. 29
pg. 29
pg. 30
pg. 31
pg. 60
To Next Page
Loading...
