App Setup
Because the GarageSmart™ app is designed to be used in both Residential and
Commercial use, there are two modes that the GarageSmart™ app can run in, Classic
mode or Advanced mode.
This section will show how to setup the GarageSmart
™
app in Advanced mode, using a
User, Remote Key and Access Code. In Advanced mode a User can be granted
access to multiple locations to control multiple doors one at a time or even
simultaneously.
Further information on the differences between Classic and Advanced can be found
within the Online Control Panel Manual, that can be found by logging into your Online
Control Panel, then clicking on Help.
1. Find and run the GarageSmart
™
app that is installed on your device.
2. The App Settings page will automatically be shown; the first time the app is opened
(after installation). If not, from the main screen of the GarageSmart™ App, click the
Settings icon, then App Settings.
Set App Mode to Advanced and make any other changes as necessary.