Need help?Do you have a question about the Gardner Denver AUTO SENTRY-ES+ and is the answer not in the manual?
General| Category | Controller |
|---|---|
| Model | AUTO SENTRY-ES+ |
| Input Voltage | 120/240 VAC |
| Operating Temperature | -20°C to 60°C |
| Communication Protocol | Modbus RTU |
| Output Type | Relay |
| Number of Inputs | 8 |
| Number of Outputs | 6 |
Overview of the compressor unit and its controls.
How to operate the controller, its modes, and display functions.
Details protective shutdown conditions and service advisories.
Guide to configuring controller settings, adjustments, and maintenance.
Details on features like current limiting and auto restart.
How to set up and operate multi-compressor systems.
Specifies requirements, installation, and wiring for remote starters.
How to connect and verify remote starter controls and operation.
Specifies requirements, installation, and wiring for remote cooling module starters.
How to connect and verify cooling module starter controls and operation.
Instructions for replacing and upgrading the controller unit.
Details on PC software for service and available accessory kits.
To Next Page
