owner’s manual for use with models 10, 20, 30 51
Appendix
EN
Problem Solution
My device is connected
to the computer, but it
will not go into mass
storage mode.
You may have loaded a corrupted le.
1. Disconnect the device from your computer.
2. Turn off the device.
3. Hold while you connect the device to your
computer.
4. Continue holding for 30 seconds or until the device
goes into mass storage mode.
I cannot see any new
removable drives in
my list of drives.
If you have several network drives mapped on your
computer, Windows may have trouble assigning drive
letters to your Garmin drives. See the Help le for your
operating system to learn how to assign drive letters.
I need replacement
parts or accessories.
Go to http://buy.garmin.com, or contact your Garmin
dealer.
I want to buy an
external GPS antenna.
Go to http://buy.garmin.com, or contact your Garmin
dealer.
To Next Page
