19
Ground Track
When switched on, Ground Track slowly tracks to
changes in ground mineralization by automatically
adjusting the ground balance values. However, when
entering a new area, you should first perform Ground
Balance to quickly obtain a good starting point.
Press the MENU button until GND TRACK is selected,
then press the MENU Plus (+) or Minus (-) buttons to
scroll through the four Ground Track settings: OFF,
SLOW, MED and FAST.
OFF: Ground Tracking is not activated and the
ground balance values will remain fixed at
their current values. OFF is the default setting
and is preferred unless tracking is needed to
address frequently changing ground
conditions.
SLOW: The ground balance values will very slowly
track to slowly changing ground conditions.
MED: The ground balance values will track a little
faster to changes in ground conditions.
FAST: The ground balance values will track even
faster for use in quickly changing ground
conditions, but this setting may also produce
the greatest loss in detection depth.
Note: Ground Track may reduce detection depth
due to slowly tracking to a target, especially with
repeated swings over the target and when set to
faster settings. Therefore, Ground Track should only be
used when changing ground mineralization requires
frequent re-ground balancing. Utilize only as much
tracking speed as necessary to keep ground responses
sufficiently suppressed. If Ground Track is ON but
ground balance values remains fairly constant, this
indicates ground conditions may be stable enough to
switch Ground Track OFF.
Ground Trend Arrows
When Ground Track is ON, arrows will show the
trending direction of the changing ground balance
values.
Press MENU repeatedly to reach Ground Track, then use Plus
/ Minus buttons to select desired setting.
Ground Balance values
Ground Trend arrows
To Next Page
Loading...
Need help?
General
