CS 5000
User Manual
©2009 GARRETT METAL DETECTORS 13 PN 1530100 REV H
3.2.5 Use the remaining screws and washers to attach the Crosspiece to the two panels, as shown
3.2.6 Tighten all eight screws securely with a slotted screwdriver.
3.2.7 With two or more people lift to a vertical position and move to location.
3.3.8 Check for stability of unit, which is important for proper operation and safety. If the floor proves
to be uneven, either shim a corner or slightly loosen the screws connecting the Detection Unit
and Overhead Crosspiece to the Side Panels and adjust as necessary.
3.3.9 Connect to the power line, and proceed with Installation Adjustments (See Section 5.)
To Next Page
Loading...
