Garrett CS 5000 - 8 Technical Specifications

CS 5000
User Manual
© 2009 GARRETT METAL DETECTORS 22 PN 1530100 REV H
8. TECHNICAL SPECIFICATIONS
8.1 ELECTRONICS
Digital-controlled pulse induction metal detector with microprocessors utilized in both detection
and control circuitry. Designed for tailoring specific programs to fulfill various security applications.
Electronics are modular and designed for easy plug-in and change-out.
8.2 MEMORY
All program selections and settings are maintained in electrically erasable non-volatile memory. The
unit will maintain all settings even when disconnected from power. No battery is required for memory
retention.
8.3 OVERHEAD CONTROL UNIT
LCD Display, LED bar graph and control touchpads plus all wiring, connections and electronics are
integrated in a single overhead compartment that eliminates exposed wires and an external control
box.
8.4 CONTROL OUTPUTS
Low-voltagesolidstateswitches.ACswitchcancontrol48Vat100mA;normallyopenswitchisiso-
lated from system ground. DC switch can sink 100mA from a 15V source. Connections to 15V and
system ground are provided for use with internal or external power source.
8.5 CONNECTORS
AC switches, DC switches and synchronization are connected through a screw terminal block. Remote
indicators and remote console are connected through RJ-45 telephone- type connections.
8.6 INDICATORS
READYlightindicatesunitisoperational;ALARM light and audible alarm are activated when target
amountofmetalisdetected;LEDBarGraphindicatesamplitudeofalarmsignal.
8.7 TRAFFIC COUNTER
Built-in and resettable with current reading easily available on LCD panel.
8.8 TAMPERPROOF
Dual access codes required to set or change the operation of the unit: one level for use by superviors
in selectingprogramsandsensitivity;the other for initial set-up and overall control.Securityofthe
unit’s calibration settings is further protected by a non-resettable sequence code that allows supervi-
sors to maintain a precise log of all changes ever made to the program, sensitivity or set-up, as well
as any attempts at changing them. An audible alarm reports any unauthorized attempt at access.
8.9 CONSTRUCTION
Attractivescratch-andmar-resistantlaminatewithresilientendcaps;controlpanelandcrosspieces
of heavy duty aluminum.
8.10 REGULATORY STANDARDS
The Garrett CS 5000 programs have been designed specifically to meet (or exceed) all 1991 Federal
Aviation Administration airport applications specifications as well as all requirements of National
Institute of Law Enforcement and Criminal Justice (NILECJ) standard 0601.00, security levels 1-5.