24
www.gateway.com
Using the cord cover
After you have the power and peripheral device cords connected to your computer, you
can install the optional cord cover to make your computer look less cluttered.
To install the optional cord cover:
■ Align the tabs on the top of the cover with the slots above the back ports, then swing
the cord cover’s bottom tabs into the slots on the bottom of the computer (view shown
from below for clarity).
To remove the cord cover:
■ Press the cord cover’s bottom tabs inward, then rotate the cord cover away from the
computer.
Tips & Tricks If you have difficulty sliding the cover’s bottom tabs into the computer
slots, press the bottom corners of the cord cover inward while
pressing the cord cover into place.
To Next Page
Loading...
Need help?
General
