150 Using the Solo Docking Station
Adjusting audio settings
Your notebook is configured to use only its internal audio connections and
speakers, even while docked. To enable the docking station’s external speakers
and audio connections, you must change audio settings (the settings are
changed automatically in Windows NT and Windows 2000). You can also
configure the notebook’s internal speakers (analog audio) to pass through the
digital audio connection to the docking station.
To enable the docking station’s external speakers and audio connections in
Windows Me:
1 Double-click the speaker icon on the taskbar. The Volume Control dialog
box opens.
2 Click
Advanced. The Advanced Controls for Volume Control dialog box
opens.
3 Click
Docked Speakers for analog audio. The docking station audio
connectors are enabled. See “Right side” on page 146 to locate the analog
audio output connector.
- OR -
Click
Enable S/PDIF for digital audio. The docking station digital audio
connector is enabled. For the S/PDIF digital audio output connector’s
location, see “Left side” on page 143.
To Next Page
Loading...
