Glossary G-5
G
Inline - same as "in series with", or directly behind another device. The
FusionPunch II is inline with the printer and the Stacker, in turn, is inline
with the FusionPunch II.
Misfeed - a condition that occurs when paper becomes folded or wrinkled
and becomes stuck while feeding, thereby causing a paper jam.
Offline - when finishing devices are not being fed or controlled by the
printer in a live production run. When the FusionPunch II and Stacker are
being fed manually, they are in offline mode. Many setup and error
recovery operations are done offline.
Offset Stacked - an automatic machine method of stacking documents in a
staggered, side-to-side fashion so that each individual document (e.g., book
or manual) is separated from the next.
One-Sided - a printing job that uses only one side of the paper, also called
Single-Sided.
Online - the opposite of Offline; when the finishing devices are being fed
and controlled automatically by the printer in a live production run.
Operator - the person responsible for the operation of the printer and
finishing devices. The Operator starts production jobs and sees them
through to completion.
Pressure Bar Release Levers - two levers that are used to lock or release
the Pressure Bar, a machined steel bar located on top of the Die Set. You
would remove the Die Set from the machine and release the Pressure bar to
access and remove die pins, or change damaged pins.
To Next Page
Loading...
Need help?
General
