Error Messages 3-5
3
Error Messages
From the Printer
The following is a listing of Punch-related error messages that could appear
on the Host Printer display screen. Also included are a description of the
possible causes and the resolution for each problem.
Error Message Possible Cause Resolution
DocuTech 135:
Clear External Finisher
to run jobs to the
Bypass Transport/
External Finisher not
ready.
1. The current job has
a fault and must be
reset.
2. The FusionPunch II
is not Online.
1. Click on the Printer icon.
If there is a reset option,
select Reset .
2. Press Stop/Reset
at the Punch and then press
"ONLINE/OFFLINE".
Ensure that the Punch is in
the Online mode and then
press Start .
DocuTech 135:
External Finisher Full.
The Punch has filled
the Stacker and is
waiting to be
emptied.
Unload the Stacker and
then restart the Punch
Online.
DocuTech 61XX:
Clear External Finisher
to run jobs to the
Bypass Transport or
External Finisher not
ready.
The FusionPunch II
is not Online.
Press Stop/Reset
at the Punch and then press
"ONLINE/OFFLINE".
Ensure that the Punch is in
the Online mode and then
press Start .
Figure 3-3: Printer-Generated Error Messages
To Next Page
Loading...