GBC 16 Series User Manual

2-20 General Procedures
Starting a Job
Bypassing to a Downstream device
To prepare for starting a printing job and sending it to the Bypass
Destination, as well as the Downstream device, perform the following
procedures.
1 Set up the FusionPunch II in the Bypass Destination, as well as the
correct Punch mode (For FusionPunch II setup, refer to the Getting
Started section, On-line / Off-line). Once the FusionPunch II is setup
for the application, go to the Downstream device and enable it for
On-line operation.
2 From the DocuSP Print Services screen, open the Printer Manager
window and click on the Finishing Icon.
The Finishing Window will display, defaulted to the Finishing tab, as
shown below.
Figure 2-18: The Finishing Window

GBC 16 Series Specifications

General

Brand	GBC
Model	16 Series
Category	Printer Accessories
Language	English