EasyManuals Logo

GBC 16 Series User Manual

GBC 16 Series
132 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #63 background imageLoading...
Page #63 background image
Starting a Job 2-21
2
3 Click on the On-line Finishers tab. The window will display as shown
below.
Figure 2-19: On-line Finishers tab
4 Verify that the profile for the Downstream device to be used is
Enabled.
l
For punching and stacking the 11" edge in the Xerox High Capacity
Stacker, ensure the HCS profile is Enabled.
l
For punching and stacking the 8.5" edge, ensure the GBCSE
profile is Enabled.
l
For all other applications, ensure the profile that associates with the
Downstream device to be run is Enabled.
(In the figure above is an example of a job being sent to a Signature
Booklet Maker.) If this profile is not visible in this window,
go to step 8. If this profile is visible but not Enabled (green check-mark
in the Enabled column), highlight the profile and click Enable and then
click Close.
On-line
Finishers
Ta b

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GBC 16 Series and is the answer not in the manual?

GBC 16 Series Specifications

General IconGeneral
BrandGBC
Model16 Series
CategoryPrinter Accessories
LanguageEnglish

Related product manuals