To Next Page

To Previous Page

Starting a Job 2-19

10 Go back to the On-line Finishers tab and highlite the GBC

FusionPunch II profile, then click Enable. The GBC FusionPunch II

profile should now have a green check-mark in the Enabled column.

Figure 2-17: On-line Finishers tab

11 Click Close to close this window. Now go back and follow steps 4 - 7.

Enable

Questions and Answers:

Need help?

Do you have a question about the GBC 16 Series and is the answer not in the manual?

GBC 16 Series Specifications

General