To Next Page

To Previous Page

2-18 General Procedures

9 Click the Profile Setup tab as shown in the figure below. Highlight any

enabled profile (not the GBC FusionPunch II profile) and then click

Off-line. Now highlight the GBC FusionPunch II profile and click

On-line. The GBC FusionPunch II profile should now have a green

check-mark in the On-line column as shown in the figure below.

Figure 2-16: Profile Setup tab

Profile

Setup Tab

Questions and Answers:

Need help?

Do you have a question about the GBC 16 Series and is the answer not in the manual?

GBC 16 Series Specifications

General