Control Functions and Locations 1-9
1
Punch17 - the FusionPunch II will punch the short edge
of 11 x 17 and A3 sized paper.
Punch14 - the FusionPunch II will punch the short edge
of 8.5 x 14 and 11 x 14 sized paper.
3. > Change Destination
Stack 1 - the FusionPunch II will start stacking in
Stacker #1 and then go over to Stacker #2 when Stacker
#1 is full. (The paper tray in Stacker #2 must be in the up
position for this to work.)
Stack 2 - the FusionPunch II will start stacking in
Stacker #2 and then go over to Stacker #1 when Stacker
#2 is full. (The paper tray in Stacker #1 must be in the up
position for this to work.)
S1 Only - the FusionPunch II will only stack in Stacker
#1, and will stop when it is full.
S2 Only - the FusionPunch II will only stack in Stacker
#2, and will stop when it is full.
Bypass - the FusionPunch II will Bypass all sheets to a
downstream device.
To exit this menu, press the Stop/Reset button. The
FusionPunch II will be ready for operation when the Upper
row of the LCD Display Screen displays the message:
"GBC Fusion Full Stop"
4
Raise/Lower Stacker #1 and #2
These buttons are used to raise and lower the paper trays in
the first (#1) and second (#2) stacker, if a second stacker is
present.
To Next Page
Loading...
Need help?
General
