To Next Page

To Previous Page

Starting a Job 2-15

The Finishing Window will display, defaulted to the Finishing tab.

3 Click on the On-line Finishers tab. The window will display as shown

below.

Figure 2-11: On-line Finishers tab

4 Verify that the GBC FusionPunch II profile is Enabled. If this profile

is not visible in this window, go to step 8. If this profile is visible but not

Enabled (green check-mark in the Enabled column), highlight the

profile and click Enable and then click Close.

On-line

Finishers

Ta b

Questions and Answers:

Need help?

Do you have a question about the GBC 16 Series and is the answer not in the manual?

GBC 16 Series Specifications

General