GCC Technologies EXPERT 24 - 3.1 The Control Panel; 3.1.1 Control Panel Outline

Expert 24 user manual
Operation
3-1
3.1 The Control Panel
3.1.1 The Outline of control panel
Key Function
POWER LED Indicates the power status ( LED ON: power on; LED OFF: power off )
ERROR LED Indicates the error status ( LED ON: error; LED OFF: normal )
ON/OFF LINE
Switches modes or stops cutting job (LED ON: on-
line; LED OFF:
off-line)
While in on-line mode: only ON/OFF LINE and PAUSE keys activated
While in off-line mode: the settings in VLCD can be adjusted.
PAUSE Temporarily halts the cutting process or resumes a paused job
REPEAT Repeats last job.
DATA CLEAR Clears up buffer memory.
CUT TEST Perform cutting tests on different media.
ORIGIN SET Resets origin at a new position.
4 Arrow Keys Moves carriage position, selects function, or changes setting.
3.1.2 Reset Origin
Step 1 Move the carriage to a new position.
3. Operation
Figure 3-1
Note:
 Make sure the machine is in off-line mode to enable this function.