GCC Technologies LaserPro X252RX - Page 47

- 36 - 232001240G(08)
Machine Setting Page
The Machine Setting Page allows you to access and modify a variety of your machine settings,
including: Set Lens, Tune Auto Focus, Set Table Down, Set Red Beam, Carriage Lock, Set
Command Mode, Save Position, Flash Memory, Set File Save Mode, Set Vector Mode, Tune
Image Power, Set Laser Wattage, Set Fine Mode, Other, Reset.
Machine Setting Page
Relevant Buttons
Function
F1 (Back)
Back to previous page



/



Directional
Scroll through the menu selections
Enter Perform the selection
Start / Stop Back to Main Work Page
Auto Focus Initiate the auto focus function
▲ / ▼
Manual Focus Buttons
Manually adjust the height of the work table (Z-
axis)
Main Work Page
Press
F4
☼
Navigating to this page:
Functions Page
Select <
Machine
Setting> from the menu
Machine Setting Page