1200C-2000C Fire Alarm Control Panel, Repeater, and Black Box Installation Manual 41
Appendix E: Product compliance
EN 54-2 compliance for 1200C-2000C control panels with the SD2000 module
Control panels with the SD2000 module installed have the following options with
requirements according to EN 54-2:
Table 14: EN 54-2 options with requirements with the SD2000 module
Clause Description
7.8 Output to fire alarm devices
7.9 Output to fire routing equipment
7.10 Output to fire protection equipment
7.11 Delay to output
7.12 Dependency on more than one alarm signal
7.13 Alarm counter
8.4 Total loss of the power supply
9.5 Disablement of addressable points
10 Test
EN 54-2 compliance for 1200C-2000C control panels with the VDS2000 module
Control panels with the VDS2000 module installed have the following options with
requirements according to EN 54-2:
Table 15: EN 54-2 options with requirements with the VDS2000 module
Clause Description
7.8 Output to fire alarm devices
7.9 Output to fire routing equipment (+ VDE0833)
7.10 Output to fire protection equipment (+ VdS requirements)
7.11 Delay to output
7.12 Dependency on more than one alarm signal (+ VDE0833)
7.13 Alarm counter
8.4 Total loss of the power supply
8.9 Output to fault routing equipment
9.5 Disablement of addressable points
10 Test
Control panels with the VDS2000 module also allow for:
• Interface to FBF
• Interface to FAT
• interface to FSK
• interface to Hauptmelder
• interface to EMZ