GE 29582 - Security Code Setup

3.Whenfinished,pressthe MENU buttonto confirm.Theunit beeps.
NOTE:Toskip to the next setting, press the MENUbutton. To exit setup,
press the FLASH/E×ITbutton.
Toll Saver
TollSaver can save you the cost of a call when you access your messages from
another phone:
• Ifyou havenewmessages,the unit answersafter the 2ndring.
• Ifyou haveno newmessages,the unit answersafter the Sthring.
Youcan hangupafter the3rdring andsavethe paytelephoneor longdistancecharge.
Setting the Security Code
Thisfeatureallowsyou to changethe factory default remote accesscodeusedfor
remoteaccessto youanswerer.The defaultcode is123.
1.Ifyou just adjustedthe Ringsto Answermenu,skipto Step2. Ifyou haven't
adjustedanyother setting,pressand releasethe MENUbutton until the screen
displaysREMOTEACCESS.
2 Theleft-most digit, or a (_)signwill flash indicatingthe unit isready to acceptthe
securitycodeentry.
3.Usethe keypadto entera three digit Security Code.
/4.Afterthe 3rdand last digithave beenentered,pressthe MENUbutton to storethe
securitycodeand go to the next setting.
NOTE:Toskip to the next setting, press the MENUbutton. To exit setup,
press the FLASH/E×ITbutton.
NOTE:If you make a mistake, you can use the SKIPor REPEAT
button to move between 1st to 3rd digit and input the number from
the keypad again.
16