Toaccessyour answerer:
1.Callyour telephonenumber.
2.Afteryou hear the beepthat followsthe greeting,enteryour B-digitsecuritycode.
Theunit confirmsyour codewith a doublebeepand playsthe remote menu.IFthe
wrongsecuritycode is enteredthe unit beepsthree timesand allowsfor correct
codeto beentered.
NOTE:To bypass the greeting, you can enter your 3-digit security
code any time while the greeting is playing.
Theunit waitsfor a remotecommandfor 20secondsafter the correctsecuritycode
hasbeenentered.Nenu selectionscan bemade whilethe menuis playing.
NOTE:The unit answers on the 1Oth ring when it is turned off or the
memory is full. To access the answerer, enter the 3-digit security
code after the beep. If memory is full, play messages and erase
some of them to restore memory.
NOTE:After the unit plays the remote menu, it waits 20 seconds for
a command, then disconnects.
Remote Access Commands
Playnew message 1
Playall messages 2
Repeatmessages(during messageplayback) 5
Playpreviousmessage(during messageplayback) 6
Skipto next message(during messageplayback) 7
Erasemessage(during messageplayback) 0
Stopplayback (during messageplayback) 4
Turnanswereron/off 3
Endcall 4
23
To Next Page
Loading...
