GE 469 Manual

5-30 469 Motor Management Relay GE Power Management
5.8 DIAGNOSTICS 5 ACTUAL VALUES
5
•
DEFAULT MESSAGE HAS BEEN REMOVED:
Any time a default message is removed from the default message
list, this message will appear as verification.
•
DEFAULT MESSAGES 6 OF 20 ARE ASSIGNED:
This message appears each time the
S1 469 SETUP / DEFAULT
MESSAGES
subgroup is entered. It notifies the user of the number of assigned default messages.
•
INPUT FUNCTION IS ALREADY ASSIGNED:
The Assignable Digital Input functions may only be used once. If an
attempt is made to assign the same function to two different switches, this message will appear.
•
INVALID SERVICE CODE ENTERED:
This message appears if an invalid code is entered in
S13 469 TESTING /
MULTILIN USE ONLY
.
•
KEY PRESSED HERE IS INVALID:
Under certain situations, certain keys have no function (e.g. any number key
while viewing Actual Values). If a key is pressed where it should have no function, this message will
appear.
•
DATA CLEARED SUCCESSFULLY:
This message confirms that data has been cleared or reset in the
S1 469
SETUP \ CLEAR DATA
or
S1 469 SETUP \ INSTALLATION
setpoint groups.
•
TOP OF PAGE:
This message will indicate when the top of a page has been reached.
•
BOTTOM OF PAGE:
This message will indicate when the bottom of a page has been reached.
•
TOP OF LIST:
This message will indicate when the top of subgroup has been reached.
•
BOTTOM OF LIST:
This message will indicate when the bottom of a subgroup has been reached.
•
[.] KEY IS USED TO ADVANCE THE CURSOR:
Any time a setpoint that requires text editing is viewed, this mes-
sage will appear immediately to prompt the user to use the decimal key for cursor control. If the setpoint is
not altered for 1 minute, the message will flash again.
•
NO ALARMS ACTIVE:
This message appears if an attempt is made to enter the
A1 STATUS \ ALARM STATUS
subgroup when there are no active alarms.
•
NO START BLOCKS ACTIVE:
This message appears if an attempt is made to enter the
A1 STATUS / START
BLOCKS
subgroup when there are no active Start Blocks.
•
THIS FEATURE NOT PROGRAMMED:
If an attempt is made to enter an actual value message subgroup, when
the setpoints are not configured for that feature, this message will appear.

GE 469 Specifications

General

Model	GE 469
Category	Relays
Frequency	50/60 Hz
Protection Functions	Overcurrent
Communication Protocols	Modbus, DNP3, IEC 61850
Display	LCD
Mounting	Panel