GE 469

CHAPTER 6: ACTUAL VALUES
469 MOTOR MANAGEMENT RELAY – INSTRUCTION MANUAL 6–35
Underpower Trip Undervoltage Trip Vibration Sw.Trip Volt. Frequency Trip
ALARMS (OPTIONAL EVENTS)
Analog Diff 1-2 Alarm Analog Diff 3-4 Alarm Analog I/P 1 Alarm Analog I/P 2 Alarm
Analog I/P 3 Alarm Analog I/P 4 Alarm Breaker Failure Control Alarm
Counter Alarm Current Demand Alarm Current U/B Alarm General Sw.A Alarm
General Sw.B Alarm General Sw.C Alarm General Sw.D Alarm Ground Fault Alarm
kVA Demand Alarm kvar Demand Alarm kW Demand Alarm Open RTD Alarm
Overload Alarm Overtorque Alarm Overvoltage Alarm Power Factor Alarm
Pressure Sw. Alarm Reactive Power Alarm Remote Alarm Reverse Power Alarm
RTD 1 Alarm RTD 2 Alarm RTD 3 Alarm RTD 4 Alarm
RTD 5 Alarm RTD 6 Alarm RTD 7 Alarm RTD 8 Alarm
RTD 9 Alarm RTD 10 Alarm RTD 11 Alarm RTD 12 Alarm
RTD 1 High Alarm RTD 2 High Alarm RTD 3 High Alarm RTD 4 High Alarm
RTD 5 High Alarm RTD 6 High Alarm RTD 7 High Alarm RTD 8 High Alarm
RTD 9 High Alarm RTD 10 High Alarm RTD 11 High Alarm RTD 12 High Alarm
Service Alarm Short/Low RTD Alarm Starter Failed Alarm Tachometer Alarm
Thermal Model Alarm Trip Coil Super. Trip Counter Alarm Undercurrent Alarm
Underpower Alarm Undervoltage Alarm Vibration Sw. Alarm Volt. Frequency Alarm
Welded Contactor
OTHER
1 TRIP Relay Forced 2 AUX Relay Forced 3 AUX Relay Forced 4 ALARM Relay Forced
469 Not Inserted 5 BLOCK Relay Forced Control Power Applied
Control Power Lost Digital Trace Trigger Emergency Rst. Close Emergency Rst. Open
Force 1 TRIP Disabled Force 2 AUX Disabled Force 3 AUX Disabled
Force 4 ALARM
Disabled
Force 5 BLOCK
Disabled
Forced Relay Motor Started No Event/Trip to Date
Relay Not Inserted Serial Trace Trigger Service Alarm Simulation Started
Simulation Stopped Start While Blocked
Table 6–3: Cause of Events (Sheet 2 of 2)